S10 Rear End Width Chart

S10 Rear End Width Chart – The s10 10bolt 7.5/7.625 rear end is a good choice for the light low to medium horsepower small block cars. My understanding is that 4wd axles are 4 wider than that and a zr2 axle is 4. Alliance member from quincy, il porknbeaner said: Ford explorer 8.8 narrowed w/2 short side axles.

This rear is needed for a dropped 70 blazer. Look under the rear of the vehicle. Jump to latest not open for further replies. Right now im either looking at narrowing my back half on the je.

S10 Rear End Width Chart

By dencan brain looking to buy a new car but don’t know what models are compatible with your chevy rear end? Approximate rear end widths measured from backing plate to backing plate. Additionally, the s10 rear end is typically found in vehicles produced by.

The rear end is centrally located between the rear wheels. Lastly, if this beast exits from the factory, what yr and configuration of s10 do i need to locate to borrow its rear from? Look at the rpo codes in the glove box to confirm your ratio.

Add width to compensate for drums as follows: 8.5 uses a round cover and the axle tubes step down from 3 to 2 3/4 right after they exit the pumpkin. These trucks had 3.08 3.42 3.73.

We’ve compiled a chevy rear end compatibility. The 4×4’s have a wider axle, but i can’t remember exactly how much wider they are.sorry. On the back of the unit, count the number of bolts holding the inspection plate.

Chevy Truck Rear End Widths amulette